Antimicrobial and cytotoxic synergism of biocides and quorum-sensing inhibitors against uropathogenic Escherichiacoli.

BACKGROUND: Uropathogenic Escherichia coli (UPEC) are a primary cause of catheter-associated urinary tract infections (CAUTIs), often forming mature recalcitrant biofilms on the catheter surface. Anti-infective catheter coatings containing single biocides have been developed but display limited antimicrobial activity due to the selection of biocide-resistant bacterial populations. Furthermore, biocides often display cytotoxicity at concentrations required to eradicate biofilms, limiting their antiseptic potential. Quorum-sensing inhibitors (QSIs) provide a novel anti-infective approach to disrupt biofilm formation on the catheter surface and help prevent CAUTIs. AIM: To evaluate the combinatorial impact of biocides and QSIs at bacteriostatic, bactericidal and biofilm eradication concentrations in parallel to assessing cytotoxicity in a bladder smooth muscle (BSM) cell line. METHODS: Checkerboard assays were performed to determine fractional inhibitory, bactericidal, and biofilm eradication concentrations of test combinations in UPEC and combined cytotoxic effects in BSM cells. FINDINGS: Synergistic antimicrobial activity was observed between polyhexamethylene biguanide, benzalkonium chloride or silver nitrate in combination with either cinnamaldehyde or furanone-C30 against UPEC biofilms. However, furanone-C30 was cytotoxic at concentrations below those required even for bacteriostatic activity. A dose-dependent cytotoxicity profile was observed for cinnamaldehyde when in combination with BAC, PHMB or silver nitrate. Both PHMB and silver nitrate displayed combined bacteriostatic and bactericidal activity below the half-maximum inhibitory concentration (IC50). Triclosan in combination with both QSIs displayed antagonistic activity in both UPEC and BSM cells. CONCLUSION: PHMB and silver in combination with cinnamaldehyde display synergistic antimicrobial activity in UPEC at non-cytotoxic concentrations, suggesting potential as anti-infective catheter-coating agents.

Comparison of the elution properties of commercially available gentamicin and bone cement containing vancomycin with 'home-made' preparations.

AIMS: Vancomycin is commonly added to acrylic bone cement during revision arthroplasty surgery. Proprietary cement preparations containing vancomycin are available, but are significantly more expensive. We investigated whether the elution of antibiotic from 'home-made' cement containing vancomycin was comparable with more expensive commercially available vancomycin impregnated cement. MATERIALS AND METHODS: A total of 18 cement discs containing either proprietary CopalG+V; or 'home-made' CopalR+G with vancomycin added by hand, were made. Each disc contained the same amount of antibiotic (0.5 g gentamycin, 2 g vancomycin) and was immersed in ammonium acetate buffer in a sealed container. Fluid from each container was sampled at eight time points over a two-week period. The concentrations of gentamicin and vancomycin in the fluid were analysed using high performance liquid chromatography mass spectrometry. RESULTS: The highest peak concentrations of antibiotic were observed from the 'home-made' cements containing vancomycin, added as in the operating theatre. The overall elution of antibiotic was, fivefold (vancomycin) and twofold (gentamicin) greater from the 'home-made' mix compared with the commercially mixed cement. The use of a vacuum during mixing had no significant effect on antibiotic elution in any of the samples. CONCLUSION: These findings suggest that the addition of 2 g vancomycin powder to gentamicin-impregnated bone cement by hand significantly increases the elution of both antibiotics compared with commercially prepared cements containing vancomycin. We found no significant advantages of using expensive commercially produced vancomycin-impregnated cement and recommend the addition of vancomycin powder by hand in the operating theatre. Cite this article: Bone Joint J 2017;99-B:73-7.

Analysis of linezolid and tigecycline as candidates for local prophylaxis via antibiotic-loaded bone cement.

OBJECTIVES: To assess the Gram-positive-specific antibiotic linezolid and the broad-spectrum antibiotic tigecycline for use in local antibiotic delivery via antibiotic-loaded bone cement. METHODS: Linezolid and tigecycline were added to Biomet bone cement at varying concentrations. Antibiotic elution over 1 week was quantified by HPLC-MS. The effect of wear on elution over 51 h was determined using a modified TE-66 wear tester. Eluted antibiotics were used to determine the MICs for a panel of clinically relevant bacteria. The impact strength of antibiotic-loaded samples was determined using a Charpy-type impact testing apparatus. Cytotoxicity of eluted antibiotics against MG-63 cells was evaluated using an MTT assay. RESULTS: Linezolid and tigecycline eluted from bone cement to clinically relevant levels within 1 h and retained activity over 1 week. Mechanical wear significantly reduced elution of tigecycline, but had little effect on elution of linezolid. Linezolid showed low cytotoxicity towards MG-63 cells with ≤300 mg/mL resulting in >50% cell activity. Cytotoxicity of tigecycline was higher, with an IC50 of 5-10 mg/L. CONCLUSIONS: Linezolid and tigecycline retain activity after elution from bone cement. The concentration of tigecycline may need to be carefully controlled due to cytotoxicity. The effect of wear on bone cement may need to be considered if tigecycline is to be used for local delivery. Up to 10% linezolid can be added without affecting the impact strength of the bone cement. These results are promising indications for future investigation of these antibiotics for use in local antibiotic delivery strategies.

The cement spacer with multiple indentations: increasing antibiotic elution using a cement spacer 'teabag'.

We investigated whether the indentation of bone cement spacers used in revision of infected joint arthroplasty with a MacDonald dissector increased the elution of antibiotic in vitro. A total of 24 cement discs containing either 0.17 g (0.88% w/w), 0.25 g (1.41% w/w), or 0.33 g (1.75% w/w) gentamicin of constant size were made. Of these, 12 were indented with the dissector. Each disc was immersed in ammonium acetate buffer in a sealed container, and fluid from each container was sampled at zero, one, three, six, 24, 48 and 72 hours and at one, and two weeks. The concentration of gentamicin in the fluid was analysed using high performance liquid chromatography mass spectrometry. The fluid sampled at 72 hours from the indented discs containing 0.17 g gentamicin (0.88% w/w) contained a mean of 113 mcg/ml (90.12 to 143.5) compared with 44.5 mcg/ml (44.02 to 44.90) in the fluid sampled from the plain discs (p = 0.012). In discs containing 0.33 g gentamicin (1.75% w/w), the concentration eluted from the indented discs at 72 hours was a mean of 316 mcg/ml (223 to 421) compared with a mean of 118 mcg/ml (100 to 140) from the plain discs (p < 0.001). At two weeks, these significant differences persisted. At nine weeks the indented discs eluted a greater concentration for all gentamicin doses, but the difference was only significant for the discs containing 0.17 g (0.88% w/w, p = 0.006). However if the area under the curve is taken as a measure of the total antibiotic eluted, the indented discs eluted more gentamicin than the plain discs for the 0.17 g (0.88% w/w, p = 0.031), the 0.25 g (1.41% w/w, p < 0.001) and the 0.33 g (1.75% w/w, p < 0.001) discs. When preparing antibiotic spacers for use in staged revision arthroplasty surgery we recommend indenting the spacer with a MacDonald dissector to increase the elution of antibiotic.

Contrasting effects of physical wear on elution of two antibiotics from orthopedic cement.

The use of antibiotics as a supplement to bone cement for the purposes of providing a local release of antibiotics is common practice in arthroplasty surgery and the kinetics of elution of the antibiotics in such systems have been investigated previously. However, in these previous studies no account was taken of the potential effects that wear may have on the elution kinetics of the antibiotic. Here, we have modified an existing wear testing rig to allow the simultaneous study of the elution kinetics of bone cement samples containing antibiotics being subjected to immersion only and immersion and conjoint wear. The results show contrasting effects with two commonly used antibiotics. Bone cement containing daptomycin showed no substantial change in antibiotic elution due to wear, while cement containing gentamicin (the most commonly used antibiotic in this application) in contrast demonstrated a substantial reduction in the rate of antibiotic elution when wear was applied. Scanning electron microscopy revealed a possible explanation for these diverse results, due to wear-induced "sealing" of the surface in conjunction with the crystal morphology of the antibiotic.